1. Read function symbol
Press “read” button , “1” flashes 1 time
2. Signal emitting symbol
when “2” flashes ,it shows that remote controller is giving
signal to indoor unit.
3. Indoor unit number
press “8”button to select indoor unit number (1,2,3,4,5or6),
then “3” flashes continuously ,press “7” to set indoor unit
number
4. Button locked symbol
When “9” is on the state of “ ↗”,press “10”button , “4”
appears to show other buttons are locked .press
“10”again to cancel
5 Code symbol
press “9”button to select code type , When “5” is on the state
of “
↘” ,the emitting code to indoor unit is for product made in
1998.
6 Read button
Press this button to give indoor unit signal , the power
LED flashes to show indoor unit number.
7 Indoor unit number setting button
When “3” is continuously flashes ,Press this
button and give signal to indoor unit to set
the number selected.
8 Indoor unit number selection button
use these 6 buttons to select indoor unit number to be set
9 Code selection button
Use this button to select emitting code type
Normally “5” is on the state of “↗”.
10 Lock button
Press this button , “4”appears ,the other buttons will be locked
11 Reset Button
When the remote controller is abnormal , press this button with
pointed things to reset.
RESET
NO.4
READ
NO.1
NO.3NO.2
NO.5
LOCK
NO.6
SELECT
SET
READ
1
2
3
4
5
6789
1
0
1
1
9.1 Function of special remote controller (Address setting)
9 ELECTRICAL CONTROL FUNCTIONS
To Next Page
Loading...
