7. Water Kettle function introduction
(If there is no automatic water injection function, please
manually put the water into the kettle)
7.1 Use
7.1.1 From the handle side, lift up along the edge of the
upper cover to open the upper cover;
7.1.2 Fruit slices or other tea products can be placed in the
fruit tea leak;
7.1.3 When installing the fruit tea sifter and the lower cover,
it can be disassembled by rotating according to the
direction of the arrow and installed in reverse;
7.1.4 When the kettle need to be placed on the bracket, the
spout downward slightly and put it in.(Fig.7.1-2)
7.1.5 When the kettle is taken out by the kettle bracket, lift
the handle up and draw it out horizontally
7.1-1
7.1-2
This product is a fruit tea kettle with cold water, users need
to open the top cover, and then add the fruit tea.
Then the kettle is placed in the bracket to be automatically
filled with water , and taken as needed to use(Fig.7.1-1).
Only model HCW7819EHMP is available with automatic
water refill.
TIPS:
► Please turn the auto rell function on before using.
► Please turn the auto rell function o if not using in the longer period.
► Please clear up the water under the box of water jug regularly, otherwise it will cause
the auto-rell function unavailable.
► The Auto-rell function will not work well if the water pressure is lower than 0.3-0.5Mpa
► The Auto-rell function will not work when cut o the water supply, take out the water
jug and put back again will make the Auto-rell function rework when water supply.
23
EN
Use
To Next Page
Loading...
Need help?
General
