Haier Cube 83 - Page 28

Notice
▶ The temperature of clean water cannot exceed 60℃;
Do not use dishwasher for cleaning;▶
Notice
1. The temperature of filling drinks in the kettle should not exceed 60
℃
.
2. If there is more splashing water in the bracket, please wipe it gently in time, otherwise
it may affect the automatic water filling function.
3. Make sure the kettle is installed in place.Otherwise, the automatic water injection function
may fail or water overflow！
4. Missing to rotate and disassemble fruit tea according to the direction indicated by the arrow.
5. Drink the tea in the kettle within 24 hours, and too much time will easily cause deterioration
6. The kettle should be cleaned in time if it is filled with tea or not used for a long time
7.2 Clean
7.2.1Take off the cover;
7.2.2 Divide the lid into upper lid, lower lid and fruit tea leak.
7.2.3 Clean the kettle and its parts with a soft sponge dipped in water.
7.2.4 Use a diluted dishware cleaner to remove stubborn stains.
Rinse with water after stains are removed.
7. The kettle can be filled with just water without adding fruit or tea.
TIPS:
► Please take o the packing lm of water jug before power on the product
► Do not ll the drinks that over 60ºC in the water jug.
► Follow the instructions to unpack the tea leak
► Please ensure the water jug set the right position, otherwise it may cause the function
fail or water overow.
► Please ensure the auto ll function have turned on before using it (HCW7819EHMP)
► The tea bag or coee bag can be placed in the water jug, turn o the auto ll function
when ll the beverage in the jug.
► Please nish the tea in 24h, otherwise it may cause the deterioration.
► Please turn o the auto ll function and clean the jug if not using it during the longer
period.
► Please clear up the water under the box of water jug regularly, otherwise it will cause
the auto-rell function unavailable (HCW7819EHMP).
► The Auto-rell function will not work well if the water pressure is lower than 0.3-0.5Mpa
► The Auto-rell function will not work when cut o the water supply, take out the water
jug and put back again will make the Auto-rell function rework when water supply
24
EN
Use