Haier DW12-CBE5 Use And Maintenance Manual

Trouble shooting
It may occur that the dishwasher does not function or does not
function properly. Before calling for assistance, use this trouble
shooting guide to see if you can resolve the problem yourself:
Dishwasher does not start
Have you checked whether:
- the plug is firmly pushed into the socket;
- the power is on in the house;
- the door is closed properly;
- the ON-OFF switch is on “ON”;
- the water supply is turned on.
The dishwasher does not have any water
Have you checked whether:
- The water is turned on and the hose is connected properly.
- The water supply to the house is on and has sufficient pressure.
- the water supply hose is creased or kinked.
- the filter for the water supply hose is clogged.
Dishes are not clean
Have you checked whether:
- The water is turned on and the hose is connected properly.
- The water supply to the house is on and has sufficient pressure.
- the water supply hose is creased or kinked.
- the filter for the water supply hose is clogged.
Dishwasher does not drain
Have you checked whether:
- the drain hose is creased or kinked.
Lime deposits or a white film form on the dishes
Have you checked whether:
- the salt container lid is closed properly;
- the rinse aid dosage is correct.
Error messages
The dishwasher is equipped with a safety system that is able to
detect operating problems and malfunctions. These malfunctions
are signalled by the rapid blinking of one of the program LEDs
“F”. Only where the indicator light for the soak cycle (see table for
cycles) blinks rapidly should you cancel the cycle as described in
the section entitled “Changing a Cycle while Underway.” Then
check to make sure that the water supply is working and that the
tap is turned on. If the message continues, call for technical
assistance, indicating which message appeared.
If any of the other indicator lights begins to blink rapidly, turn off
the appliance and call for technical assistance, indicating which
light began to blink.
If, despite all these checks, the dishwasher still does not function
and/or the problem persists, contact the nearest authorised ser-
vice centre and provide them with the following information:
- the nature of the problem;
- the model type number (Mod...) And the
serial number (S/N...), which are shown on the plate located
on the inner of the door.
Never use unauthorised technicians and refuse parts that
are not original spare parts.
.9.
GB

Haier DW12-CBE5 Specifications

General

Brand	Haier
Model	DW12-CBE5
Category	Dishwasher
Language	English