9
Service Manual
Model No.DW12-TFE3 Series
Issue
Rev.
Attention:
The connecting piece for syphon trap (U-bend) must be securely fastened to the wall to
prevent the drain hose from moving and allowing water to spill outside the drain.
4-8.Electrical Connection
After making sure that the voltage and frequency values for the current in the home correspond to
those on the rating plate (located on the stainless steel inner door of the appliance) and that the
electrical system is correct for the maximum voltage on the rating plate, insert the plug into an
electrical socket which is earthed properly (the earthing of the appliance is a safety requirement
mandated by law).
If the electrical socket to which the appliance must be connected is not appropriate for the plug,
replace the whole cable, rather than using adaptors or the like as they could cause overheating
and burns.
Caution:
The dishwasher plug must be accessible even when the appliance is installed as a built-in
unit so that maintenance can be done safely.
fig.C
To Next Page
Loading...
Need help?
General
