EasyManuals Logo

Haier DW45BI User Manual

Haier DW45BI
8 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #3 background imageLoading...
Page #3 background image
Salt



Salt
The hardness of the water varies from place to place. If hard
water is used in the dishwasher, deposits will form on the dishes
and utensils.
The appliance is equipped with a special softener that uses a salt
specifically designed to eliminate lime and minerals from the water.
Loading the Salt into the Softener
Always use salt intended for use with dishwashers.
The salt container is located beneath the lower rack and should
be filled as follows:
- Remove the lower rack and then unscrew and remove the cap
from the salt container;
- If you are filling the container for the first time, fill it with water;
- Place the end of the funnel (supplied) into the hole and intro-
duce about 2 kg of salt. It is normal for a small amount of water
to come out of the salt container.
- Carefully screw the cap back on.
The salt container must be filled when the "low salt" indicator
light (located on the control panel), comes on.
To prevent the formation of rust, load the salt just before begin-
ning a wash cycle.
Adjusting Salt Consumption
The dishwasher is designed to allow for adjusting the amount of
salt consumed based on the hardness of the water used. This is
intended to optimize and customize the level of salt consumption
so that it remains at a minimum.
To adjust salt consumption, proceed as follows:
- Unscrew the cap from the salt container;
- There is a ring on the container with an arrow on it (see figure to
the side),
- If necessary, rotate the ring in an anticlockwise direction from
the "-" setting towards the "+" sign, based on the hardness of
the water being used.
It is recommended that adjustments be made in accordance
with the following schema:
.3.
Water Hardness
Clarke
degrees
ºdH
mmol/l
Selector
position
Salt
consumption
(Grams/cycle)
Autonomy
(cycles/2kg)
014 MNT MNIT
NIUQIQNUQQNQPS
PSTN QRUV Q I R UIV
[UV[TN [UIV
L
=?J?
jba
LM
OM
QM
SM?H?
SM
QM
OR
Level
1
2
3
4
GB
GB
Close-up View (Interior)
A
B
C
D
Upper Rack
Top Spray Arm
Rack Height Adjustor
Lower Rack
E
F
G
H
Washing Filter
Detergent and Rinse Aid Dispenser
Bottom Spray Arm
Technical characteristics
45 cm
58 cm
82 cm
9 standard place settings
0.03-0.6MPa
220-240V~ 50Hz
2150W
Width
Depth
Height
Capacity
Mains water pressure
Power voltage
Maximum load
Third Sprayer
.2.
A
B
C
D
E
G
H
F

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Haier DW45BI and is the answer not in the manual?

Haier DW45BI Specifications

General IconGeneral
BrandHaier
ModelDW45BI
CategoryDishwasher
LanguageEnglish

Related product manuals