Haier DW60BI User Manual

.9.
Troubleshooting
GB
It may occur that the dishwasher does not function or does not
function properly. Before calling for assistance, Iet us see what
can be done first: have you forgotten to press one of the buttons
or to perform an essential operation?
The Dishwasher Does Not Start
Have you checked whether:
- the plug is pushed into the socket correctly;
- the power is on in the house;
- the door is closed properly;
- the ON-OFF switch is on "ON";
- the water supply is turned on.
The Dishwasher Does Not Load Water
Have you checked whether:
- the water is turned on and the hose is connected properly;
- the water supply to the house is on and has sufficient pressure;
- the water supply hose is crimped or bent;
- the filter for the water supply hose is clogged.
The Dishes Are Not Clean
Have you checked whether:
- the water is turned on and the hose is connected properly;
- the water supply to the house is on and has sufficient pressure;
- the water supply hose is crimped or bent;
- the filter for the water supply hose is clogged.
The Dishwasher Does Not Drain
Have you checked whether:
- the drain hose is crimped or bent.
Lime Deposits or a White Film Form on the Dishes
Have you checked whether:
- the lid to the salt container is closed properly;
- the rinse aid dosage is correct.
Error message
Error display on the time-remaining indicator
When all the programme indicators “ D” blink.
Have you checked whether:
- the door is closed properly.
When the programme indicators “ D1,D3,D5” blink.
Have you checked whether:
- the drain hose is crimped or bent.
- the drain hose is too high.
D
If you take all these checks and the dishwasher still does not
function or your dishwasher have any other error display, you
can power the dishwasher OFF, and wait a few minutes. You can
power the dishwasher on, try it again , if the dishwasher still does
not function and/or the problem persists, contact the nearest
authorised service center and provide them with the following
information:
Never call on unauthorised technicians and refuse to
allow parts to be installed that are not original spare
parts.
- the nature of the problem.
- the model type number (Mod...) And the serial number (S/N...),
which are indicated on the plate located on the side of the inner
part of the door.
When the programme indicators “D1,D2,D3” blink.
Have you checked whether:
- the water is turned on and the hose is connected properly;
- the water supply to the house is on and has sufficient pressure;
- the water supply hose is crimped or bent;
- the filter for the water supply hose is clogged.
- the drain hose is too low.
D2 D4D3
D1 D2

Haier DW60BI Specifications

General

Brand	Haier
Model	DW60BI
Category	Dishwasher
Language	English