7
Model No: ES15V-Q1(R)
Issue
Rev.
No
.2014
A
2.Installation
2.1 General requirements
if not avoided, could result
in property damage
The wall for installation shall be solid and reliable which can bear more 4 times
of weight of the heater with full of water.
The installation position shall be with a floor drain and can facilitate for use and
maintenance. And the facilities will not be damaged nearby or downstairs even
leakage of tank or conduit has been taken place.
The electric water heater should be installed indoors with ambient temperature
above 0°C.
Power supply
To ensure safety, please use a separate socket which is
reliably grounded and complies with the national standard.
Never use the water heater when it is not reliably grounded.
Check with an electro-probe to ensure that the live wire and
the neutral wire are not connected reversely.
Check that the electric wire diameter is no less than 1.5mm,
the power socket is earthed well, and the voltage of power
is between 220V to 240V.
To Next Page
Loading...
Need help?
General
