Haier ESD200 - Troubleshooting

26
Troubleshooting
Dishwasher does not work:
• Check if the circuit breaker needs to be reset or if the fuse needs to be replaced.
• Check if the unit is in "OFF" mode.
• Check if the door is open. You may need to close the door properly.
• Check that you have pressed "POWER" button after proper selection.
Dishware and glassware/flatware are cloudy
and not properly cleaned:
• Use of old or poor detergent.
You need to make sure that detergent is fresh.
• The water may be hard in your area.
You may need to install a water softener.
• Spray arms may be blocked.
You may need to rearrange dishware and utensils.
• Water pressure may be low.
You may need to adjust the water pressure.
Make sure it is between 20 to 120 (PSI).
• Water temperature may be lower than what is recommended.
(120 Degree F / 49 Degree C) You may need to adjust the water temperature on
your water heater.
• Overloading of dishware.
You may need to rearrange or remove some dishware from the load.
• (May have selected wrong cycle.) Inappropraite cycle selection.
You may need to select the proper cycle.
Dishes are not dry:
• Low water temperature.
You may need to regulate the water temperature to 120 Degree F / 49 Degree C
or select Hi-Temp Wash option.
• Make sure the rinse agent dispenser is filled and the proper amount is used.
• Avoid nesting and do not overload.
• Load items in a tilted position if possible so the water will run off easily.
• Dishware washed in higher temperatures will dry faster.
• Some plastic materials may need to be towel dried.
English
ESD200-MANUAL 1/10/03 11:29 AM Page 28