- 12 -
>
Installation of legs requires the joint efforts of at least two adults. Don’t
attempt to handle it by self. Make sure the appliance is not tilted too
much to fall down.Before moving a refrigerator, the adjustable legs
should be removed to prevent floor damage.
Installing Legs
Take out the accessory bag containing the legs from the refrigerator
compartment. Get the legs to be installed. The appliance should be given a tilt
by one person and the legs should be installed as illustrated into the reserved
holes by the other person.
NOTE
Leg
Reserved
hole
Removing & Replacing Door Handle
Take out the door handles from the refrigerator compartment (2 longer handles
to be installed on the refrigerator and 1 shorter handle to be installed on the
freezer). The following instructions should be observed.
Removing & Replacing Refrigerator Door Handle
Get 2 fasteners out of the accessory bag and place them in 2 reserved holes in
the left door. Install a handle by attaching the reinforcing plate to the fasteners
and then pushing the handle downwards into its place. Install the right handle
in the same way. To remove the handle, push it upwards.
Fastener
Reinforcing
plate
To Next Page
Loading...
Need help?
General
