Front Load Washer Model:HBF600T
Troubleshooting
I .The appliance does not work.
Possible causes
1.The socket is not the required one or the connection is loose.
2.The door is not properly closed or the switch of micro delay is in poor contact.
3.The plug wire of motor is in poor contact or the motor is broken.
4.Malfunction of electronic module
Troubleshooting
1.Check the socket and plug to make sure that they are properly connected.
2.Check whether the micro delay switch is in good contact in on-position. If yes, insert the terminal firmly
to provide a good connection.
3.The electronic module controls the rotary speed and direction of the motor. In case of the failure, check
the wiring or replace the electronic module.
II .Filling failur
Possible causes
1.The switch of water supply is not opened or the water pressure is too low.
2.The door is not properly closed or the micro delay switch is in poor contact
3.The water electromagnetic valve is broken.
4.The plug wire of drainage pump is in poor contact.
5.The pressure switch is broken.
Troubleshooting
1.Repeat the following steps.
1).Open the switch of water supply
2).Check whether the filling hose is twisted or blocked.
3).Check whether the water eletromagnetic valve is blocked.
4).Check whether program is properly selected.
5).Check whether the water supply pressure is too low.
2.Check the door catch and the door lock are in good contact. If not, make necessary adjustment. Check
whether the micro delay switch is in good contact in on-position.
3.Check whether the electromagnetic is good in on-position. Fasten it if necessary.
4.Blow on the pressure switch and "click, click" can be heard. Otherwise, replace the pressure switch with
a new one.
III .No drainage
Possible causes
1.Improper installation
2.The drainage pump is broken.
Troubleshooting
To Next Page
Loading...
Need help?
General
