5. Close inlet grill
4. Install air filter
Put filter into protruding parts at the top of the
inlet grill.
[Clean outlet and shell]
CAUTION!
Don't use gasoline, benzene, dilutant, polishing
powder, or liquid inseticide.
CAUTION!
3. Clean
(A) Remove dust with vacuum filter.
Maintenance
[Clean air filter]
NOTE
1. Open inlet grill
When having to clean, don't dismantle air-filter,otherwise may cause faults.
In the environment where there is too much dust, air filter should be cleaned for
more times.
(about half a year one time)
(B) Wash with water.
Swing off the water,
and then place in cool
place.
Pull the two handles at the same
time, slowly draw them out.
2. Dismantle air filter
Clip cpening
Bottom of filter
Frame of air inlet grill
the reverse sequance of 1.
Don't wash with water over 50 , to prevent
discoloring or deforming.
Don't dry over fire. Filter maybe burn.
7
With too much dust, use soft brush and neutral
detergent.
Don't wash with water over 50 , otherwise may
cause discoloring or deforming.
Use soft dry cloth to scrub.
If duse not removed,can use water or neutral
detergent.
If ceiling built-in conditioner's swing plate too
dirty, it can be dimantled(as described below)
and cleaned.
Remove the air inlet grill
To Next Page
Loading...
Need help?
General
