Method of water charging
Charge water from
air outlet
Charge water from
inspecting hole
Watering can of plastic
pipe should be about
100 mm long
100mm
Water drainage port for
maintenance
(Drain water from
this hole)
Self-provided stiff pipe
Maintenance
Inspecting hole
1 2 3 D
Wiring
All supplied parts. materials and wiring operation must in appliance with
local code and regulations.
Use copper wire only.
When make wiring, please refer to wiring diagram also.
All wiring work must be done by qualified electricians.
A circuit breaker must be installed, which can cut power supply to all system.
See Installation Manual of outdoor unit for specifications of wires, circuit breaker, switches and wiring etc.
Connecting of unit
Remove cover of switch box (1) , drag wires into rubber tube A, then, after proper wiring with other wires,
tighten clamp A. Connect wires of correct pole to the terminal block inside.
Wind seal
12 around wires. (Be sure to do that, or, dew may occur).
Upon connecting, replace control box cover (1) and (2).
Cover of controll box
PCB on
indoor unit
Terminal block
Connect with
outdoor unit
Terminal block
P2A
O<J
456
G456
P2A
JKL
B<M075=@36 B<M075=C36
B<M075=B36 B<M075BC36
7
E
P2A
P2A
IHO?J KMIIEP:
4IB/5530563Nj/83Bi
O<J<JAJ
45678
P2A
P2A
O<J
456
B<M059B@36 B<M059BB36
O<
O<J<JAJ
45678
P2A
P2A
IHO?J KMIIEP:
6Gj/6930733N/83Bi
GHL?: E/ G Q]T 4/ 5 QaU U`dQ[ ^] cXU cUa\Y]Q[ R[^SZ1
O<J O <
456 EG
B<M059=@36 B<M059=B36
P2A P2A
P2A
IHO?J KMIIEP:
4IB/5530563Nj/83Bi
HML>HHJ MGCL L?JFCG;E <EH=D
CG>HHJ MGCL L?JFCG;E <EH=D
HML>HHJ MGCL L?JFCG;E <EH=D
CG>HHJ MGCL L?JFCG;E <EH=D
CG>HHJ MGCL L?JFCG;E <EH=D
HML>HHJ MGCL L?JFCG;E <EH=D
G
5
P2A
Installation
To Next Page
Loading...
Need help?
General
