TROUBLESHOOTING
- 3 -
Problem
Analysis
Does not run
·If the protector trip or fuse is blown.
·Please wait for 3 minutes and start again, protector
device may be preventing unit to work.
·If batteries in the remote controller exhausted.
·If the plug is not properly plugged.
Run a short while
only
Run but not cool
Do not run and water
full indicator lights
·If the set temperature is close to
you can low the set temperature.
·Air outlet be blocked by obstacle.
Take the obstacle away.
room temperature,
·If the door or window open.
·If there is other heater appliance work,
like heater or lamp, etc...
·The air filter is dirty, please clean it.
·Air outlet or intake be blocked.
·Set temperature is too high.
·Drain the water into a prepared container by the drainage
pipe on the rear panel of the unit.
If still doesn't work, please consult a qualified technician.
To Next Page
Loading...
Need help?
General
