TROUBLESHOOTING
f Trouble Analysis
\
Does not run
Run a short while only
Run but not cool
Do not run and water
full indicator lights
-If the protector trip or fuse is blown.
•Please wait for 3 minutes and start again,
protector device may be preventing unit
to work.
•If batteries in the remote controller exhausted.
•If the plug is not properly plugged•
-if the set temperature is close to
room temperature, you can low the
set temperature•
•Air outlet be blocked by obstacle.
Take the obstacle away.
•If the door or window open.
• If there is other heater appliance work,
like heater or lamp, etc...
.The air filter is dirty, please clean it.
-Air outlet or intake be blocked.
•Set temperature is too high.
•Drain the water into a prepared container by
the drainage pipe on the rear panel of the unit.
If still doesn't work, please consult a qualified
technician.
=3-
To Next Page
Loading...
