on
1、Detect whether main control panel, display panel
and frequency conversion panel is matching ;
2、detect whether frequency conversion panel and
main control panel is connected properly;
3、Detect whether Connecting line between
frequency conversion panel and compressor is
normal;
4 、 Detect whether main control panel outpu
2
Door body is
uneven
Side by side series:
1、Minor unevenness can adjust bottom foot;
2、 Large height difference can increase the gasket
in the lower hinge parts;
3、
djustable hinge door body can adjust hinge to be
even;
Adjust & Repair
Screwdriver、
multimeter 、
poke rod
3
Fridge is in
deep freeze
cooling
1、Closing the fridge air outlet, detect air outlet
position and assembly whether cold air blowing
around, if that is not tightly sealed;
2、Take fridge electric air outlet apart, repeatedly
switching freezer, detect whether air door can freely
switch on/off, and close closely;
3、If the Department does not move, you can test
damper wiring terminal position and the main control
panel ,and check every line`s conducting state
according to the color;
4、If line is normal but throttle can`t act, that means
main control panel or throttle fault; use the normal
throttle or main control panel for testing to confirm
final faulted piece;
5、The above detection without problems, test
whether parameters of fridge sensor 1 are normal.
1、If throttle is not
tightly sealed,
seal lax part with
Sponge article;
2、If padlock is
not tightly closed,
generally throttle
is bad;
3、maintain line
section；
4、Replace the
defective part；
5 、 Replace
sensor.
Screwdriver、
multimeter
4
Sometimes
panel shows
fault code, or
displays
1、Check connector between freezer sensor and the
box body, and the internal terminal backing out,
ensure contact well;
2、Test parameter of freezer sensor;
If terminal take
off, adjust and
repair internal
terminal
Screwdriver
To Next Page
Loading...
