Refer to the temperature level control function
3-1-4. Frost-removing operation
. The blower stops after 20 seconds
. When receiving the I21=11 signal from the outdoor unit in the heat frost-removing
mode, warm boot will be done according to the hear exchange sensor. The wind
volume control is the same with 3.1.1
When the frost-removing process if over, if the compressor is on,the wind volume
control will be warm-booted; if the compressor if switched off, the wind volume will
be weak.
3-2 cooling running
. The wind volume can be set to strong, medium and weak.
Automatica wind volume function will decide the wind volume according to the
temperature
Picture3.3
3-3. Moisture removing running
3-3-1. Compressor off, idle mode for 3 minutes
. The blower fan stops as the compressor stops
. The operation is wead after 3 minutes’ idle mode
. After 3 minutes’ ilde mode, the compressor is on.
3-3-2. Compressors on
The compressor operates as the set wind volume when the wind volume is set to
be strong, medium or weak
. The wind volume is decided according to the temperature adjusting when the
wind volume is set to be automatic.
Picture 3.4
Moisture removing running
Level H 3minutes
idle mode
CompressorOFF
Setting slightly weak
OFF weak weak setting
4.Powerful Running
. Powerful running for 15 minutes
. The running stops or ends the powerful running after 15 minutes
. The mode switch ends the powerful running
. Enter into the silent mode, normal running mode or timed switching on mode to
end the powerful running
. When in automatic mode, there are powerful and silent functions for your choice.
When the main unit is in cooling mode, it operates with powerful cooling or silent
cooling. When the main unit is in heating mode, it operates with powerful heating
or silent heathing. When the main unit is in wind-sending mode, there are no
powerful or silent modes.
4-0-1. Powerful heating
29
Model:
HSU-12HS03/R2(DB)
HSU-09HS03/R2(DB)Domestic Air Conditioner
To Next Page
Loading...
