Parts and Functions
8.
Used for unit start and stop.
9. ON/OFF button
10
. TIMER ON display
11
. FAN SPEED display
LOW HI
MED
AUTO
12. LOCK display
13
. SWING UP/DOWN display
14
. SLEEP display
15
. HEALTH display
Used to select your desired temperature.
16. Operation mode display
18. POWER/SOFT display
19
. Left/right air flow display
Remote controller: to display the TEMP setting.
20. TEMP display
21
. TIMER OFF display
22
. CLOCK display
23
. TEMP button
Used to select fan speed: LOW,MED, HI, AUTO.
24. FAN button
Used to set the health airflow mode.
25. HEALTH AIRFLOW button
26
. SWING UP/DOWN button
Used to select up or down air sending direction.
27. SWING LEFT/RIGHT button
Used to select left/right air flow.
28.
FRESH
button(optional)
Used to confirm timer and clock settings.
29. SET button
30
. POWER/SOFT button
Used to set power/soft function.
Use to set fresh air function.
When the remote controller appears abnormal,
use a sha
rp pointed article to press this button
to reset the remote controller no
rmal.
1.RESET
Used to select TIMER ON, TIMER OFF,
TIMER ON-OFF.
3. TIMER button
Used to set correct time.
4. CLOCK button
Used to select sleep mode.
5. SLEEP button
6. MODE button
7.
button
Used to lock buttons and LED display. If pressed, the
other buttons will be disabled and the lock condition
display appears. Press it once again, lock will be
canceled and lock condition display disappears.
31. LOCK
17.Singal sending display
2.LIGHT button
Control the lightening and extinguishing of
the indoor LED display board.
A B
32
1
TIMP
Used for adjusting humidity or clock time and timed
time.
Operation mode
AUTO
HEAT
FAN
COOL
Remote controller
Display board
About temperature/humidity display key:
1.under the constant temperature dehumidification mode, for the first time to enter, then the remote controller displays the set
temperature, the display panel displays the actual temperature, press this key, the temperature /humidity won’t alternate. After
adjusting the set temperature, press this key again, the remote controller will display the set temperature or the set humidity,
and the display will display the actual temperature or the actual humidity at the same time.
2.Under the other modes, press this ke
y, the display panel will display the actual humidity at present for a certain time, then the
actual humidity will automatically switch back to display temperature. The display of the remote controller won’t change.
32.
10
ć
Low-Temperature
Operation Down to 10
Heating
ć
16
10
14
21
20
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
AUTO COOL DRY
FAN
HEAT
DRY
15
28
NOTE:(1) The following functions and related displays are not availab
le:
The unit is without Self-clean function.
(2)
Used to set healthy operation.
HEALTH button
The unit will generate negative ions if this function
switched on.
6
To Next Page
Loading...
