If the wind speed is high or middle before
setting for the sleep, set for lowing the wind
speed after sleeping.
If it is low wind, no change.
5.Set the wind speed change when sleeping
Before going to bed, you can simply press the
SLEEP button and unit will operate in SLEEP
mode and bring you a sound sleep.
Use of SLEEP function
After the unit starts, set the operation status,
then press SLEEP button before which the
clock must be adjusted and time being set.
Operation Mode
1. In COOL,DRY mode
1 hours after SLEEP mode starts, temp. will
become 1
O
C higher than temp. setting. After
another 1 hours, temp. rises by 1
O
C further.
The unit will run for further 6 hours then stops.
Temp. is higher than temp. setting so that room
temperature won't be too Iow for your sleep.
Remote Controller
SLEEP operation starts SLEEP operation stops
SLEEP
operation starts
SLEEP
operation stops
Approx.6hrs
1 hr
1 hr
1 hr
3 hrs
3 hrs
Rises 1
O
C
Rises 1
O
C
Rises 1
O
C
Temp.setting
Temp.setting
Unit stop
Unit stop
In COOL, DRY mode
In HEAT mode
Decreases 2
O
C
Decreases 2
O
C
1 hr
Sleep Operation
2.
3.
In HE
AT mode
1 hours after SLEEP mode sta
rts, temp will
become 2
O
C lower than temp.
setting.After another
1 hours, temp
decrease
by 2
O
C further. After more
another 3 hour
s, temp. rises by 1
O
C
fu
rther. The
unit will run for further 3 hours then
stops.
Temp. is lower than
tem
p. setting so that room
tempe rature
won't be too high
for your sleep.
In
AUTO mode
The unit ope
rates in corresponding sleep
mode adapted to the automatically selected
ope
ration mode.
4. In FAN mode
It has no SLEEP function.
Operation
15
Note
When TIMER ON function is set,the sleeping function
can't be set up.After the sleeping function is set up,if
user resets TIMER ON function,the sleeping function
will be cancelled; the machine will be in the state of
POWER/SOFT
timing-on.
Power Failure Resume Function
If the unit is started for the first time, the compressor
will not start running unless 3 minutes have elapsed.
When the power resumes after power failure, the
unit will run automatically,and 3 minutes later the
compressor starts running.
To Next Page
Loading...
