Outdoor Unit
Loading of the battery
1
2
3
4
Parts and Functions
Indoor Unit
OUTLET
INLET
CONNECTING PIPING AND ELECTRICAL WIRING
DRAIN HOSE
Remote controller
Remove the battery cover;
Load the batteries as illustrated.
2 AAA batteries, resetting key
(cylinder);
" + "/"-";
Load the battery,then put on the cover again.
Note:
Please be subject to the actual produce purchased the
above picture is just from your reference
Please be subject to the actual produce purchased the
above picture is just from your reference
Air Purifying Filter
(inside)
Inlet
1
Inlet grille
2
Outlet
3
(adjust left and
Vertical blade
right air flow)
4
Display board
Horizontal flap
(adjust up and down air flow.
Don't adjust it manually)
Emergency
Switch
6
7
8
5
1
2
3
4
5
6
7
8
4
Hint:
Remove the batteries in case won't be in use for a long period. If
there is any display after taking-out, just press reset key.
1. Mode display
2. Signal sending display
4. FAN SPEED display
5. LOCK display
6. TIMER OFF display
TIMER ON display
7.TEMP display
15. LOCK button
Used to lock buttons and LCD display
24. RESET button
When the remote controller appears
abnormal, use a sharp pointed
article to press this button to reset
21. HOUR button
Operation mode
AUTO FANCOOL DRY
Remote controller
1
2
3
4
5
9
10
11
12
13
14
15
16
21
22
23
24
18
19
20
8
17
7
6
Control the lightening and extinguishing
of the indoor LED display board.
8.
9. QUIET button
10. COOL button
11. AUTO button
12. FAN button
13. TIMER button
14. HEALTH button
16. LIGHT button
17. POWER ON/OFF button
18. DRY button
19. TEMP button
20. SWING button
22. EXTRA FUNCTION button
23.CANCEL/CONFIRM button
Function: Setting and cancel to the
timer and other additional functions.
3. SWING display
LO MED HI
AUTO
Display
circulated
Operation mode
Remote controller
QUITE
POWER
SLEEP
HEALTH
Healthy function is not available for some units.
the remote.
Be sure battery polarity is
correct
The distance from the remote to the receiver should be less than
23 feet (7 meters) with no obstructions.
Fluorescent lights or cordless telephones will reduce the range
of the remote.
If the display is dim the remote batteries may need to be replaced.
Remote malfunctions can sometimes be corrected by removing
the batteries for a few minutes and then replacing them.
Function: Air sending--- Healthy
airflow position1--- Healthy airflow
position 2 --- Restore the original
--- Right & left air airflow
--- A-B yard--- Sleeping--- Refresh air
(reserved function)
--- Power ---
Fahrenheit/Celsius mode conversion
Additional functions display
flap position
1
To Next Page
Loading...
Need help?
General
