Why is my Haier Air Conditioner not cooling properly?
If your Haier Air Conditioner isn't cooling well, first ensure the air filter is clean, as it should be cleaned every 15 days. Check for any obstructions blocking the inlet and outlet. Verify that the temperature is set correctly and that all doors and windows are closed. Use curtains to block direct sunlight. Also, consider if there are too many heat sources or people in the room.
Why does my Haier HSU18VCK Air Conditioner blow out mist or steam?
During COOL or DRY operation, your Haier Air Conditioner may blow out mist due to the rapid cooling of indoor air.
Why is there noise coming from my Haier HSU18VCK?
If you hear swishing or gurgling noises during operation or when your Haier Air Conditioner stops, especially in the first few minutes after starting, it's the refrigerant flowing through the system. A cracking noise during operation is due to the casing expanding or shrinking with temperature changes. If there's a loud noise from airflow, the air filter might be dirty.
Why can’t I change the fan speed in dry mode on my Haier Air Conditioner?
In DRY mode, when the room temperature is lower than the set temperature plus 2 degrees Celsius, your Haier Air Conditioner will run intermittently at low speed, regardless of the FAN setting.
General| Brand | Haier |
|---|---|
| Model | HSU18VCK |
| Category | Air Conditioner |
| Language | English |
Covers general warnings, pictograms, and cautions during repair work.
Details safety guidelines for electrical components, refrigerants, and post-repair installation.
Lists detailed specifications for the indoor unit, including capacity, power, and dimensions.
Provides specifications for the outdoor unit, covering compressor, refrigerant, and dimensions.
Guide to common issues and their potential causes before calling for service.
Lists indoor error codes (E1, E2, E4, E14) and their meanings.
Lists necessary tools and describes site selection for installation.
Step-by-step guide for mounting and connecting the indoor unit.
Instructions for outdoor unit placement, pipe connection, and vacuuming.
Covers drainage, leak checks, power connection, and cutting/flaring pipes.
To Next Page
