9-Troubleshooting
23
Problem Cause Solution
F7
• Motor - error. • Contact the After sales service.
FC0, FC1 or
FC2
• Abnormal communication error.
• Contact the After sales service.
UNB
• Unbalanced load - error. • Check and balance laundry load in the drum.
Reduce the load.
Problem Cause Solution
Washing machine fails
to operate.
• Programme is not yet started. • Check programme and start it.
• Door is not properly closed. • Close the door properly.
• Machine has not been switched on. • Switch the machine on.
• Power failure. • Check power supply.
• Child lock is activated. • Deactivate child lock.
Washing machine
will not be lled with
water.
• No water. • Check water tap.
• Inlet hose is kinked. • Check inlet hose.
• Inlet hose lter is blocked. • Unblock inlet hose lter.
• Water pressure is less than 0.03 MPa.
• Check water pressure.
• Door is not properly closed. • Close the door properly.
• Water supply failure. • Ensure the water supply.
Machine is draining
while being lled.
• Height of drain hose is below 80 cm.
• Make sure that drain hose is
properly installed.
• Drain hose end could reach into
water.
• Make sure the drain hose is not
in water.
Drainage failure. • Drain hose is blocked. • Unblock drain hose.
• Pump lter is blocked. • Clean pump lter.
• Drain hose end is higher than 100 cm
above floor level.
• Make sure that drain hose is
properly installed.
Strong vibration while
spinning.
• Not all transportation bolts have
been removed.
• Remove all transportation bolts
.
• Appliance has no solid position.
• Ensure solid ground and a levelled
position.
• Machine load is not correct. • Check load weight and balance.
Operation stops
before completing
wash cycle.
• Water or electric failure. • Check power and water supply.
Operation stops for
a period of time.
• Appliance displays error code. • Consider display codes.
• Problem due to load pattern. • Reduce or adjust load.
• Programme performs soaking cycle.
• Cancel programme and restart.
Excessive foam floats
drum and/or deter-
gent drawer.
• Detergent is not a appropriate. • Check detergent recommen-
dations.
• Excessive use of detergent. • Reduce amount of detergent.
9.3 Troubleshooting without display code
To Next Page
Loading...
Need help?
General
