17
Water inlet valve and inlet valve r
To prevent blockage to the water supply by ingress of foreign
substances, clean the water inlet valve and inlet valve regularly.
Moving the machine
Remove the back cover.
Remove the blanking plugs.
Tighten the bolts with a spanner.
Replace the back cover.
Long periods of disuse
ll out the electrical plug and turn o he water
moisture and odors. Let the door open while
not used.
Display Codes
Codes Causes
Err1 Door is not properly shut. Shut the door properly, and then press the
6 minutes.
lter and check the drain hose
contact the maintenance personnel.
Err3 Temperature sensor not properly
connected or damaged.
Contact the maintenance personnel.
Err4 Heater error (Appears at the end of a
cycle).
Contact the maintenance personnel.
Err5 Water level not met in 8 minutes.
The height of the drain hose is below 80
cm.
The drain hose is in water.
Make sure that tap is turned on, and water
pressure is normal.
maintenance personnel.
Install drain hose within 80-100 cm of
height.
Make sure the drain hose is not in water.
Maintenance
To Next Page
Loading...
Need help?
General
