8-Care and cleaning
GB
20
1.
2. Open service flap. You can either use a coin or a
screwdriver (Fig. 8-6.2).
3. Provide a flat container to catch leach water
(Fig. 8-6.3). There could be large amounts!
4. Pull the drainhose out and hold its end above the
container (Fig. 8-6.3).
5. Take the sealing plug out of the drainhose (Fig.
8-6.3).
6. After complete drainage close drainhose (Fig.
8-6.4). and push it back into the machine.
7. Unscrew and remove counter clockwise the pump
8. Remove contaminants and dirt (Fig. 8-6.6).
8-6.3
8-6.4
8-6.5
8-6.6
8.5 Long periods of disuse
If the appliance is left idle for a longer period:
1. Pull out the electrical plug (Fig. 8-5.1).
2.
3. Open the door to prevent formation of moisture
and odours. Leave door open while not used.
Before next use check carefully power cord, water
inlet and drain hose. Make sure everything is properly
installed and without leakage.
8-5.1 8-5.2
WARNING!
hot! Before any action please ensure water has
cooled down.
Note: Hygiene
After long periods of disuse or frequent use of low temperature washes we recom-
mended to run programme Cotton 90°C with no load and small amount of detergent in
washing agent compartment (2) or special machine cleaner to remove possibly residues.
for example if the appliance:
▶ doesn´t drain the water.
▶ doesn´t spin.
▶ cause unusual noise while running.
8-6.28-6.1
To Next Page
Loading...
Need help?
General
