9-Troubleshooting
GB
22
9.2 Troubleshooting with display code
Problem Cause Solution
E1
• Drainage error, water is not fully drained
within 6 minutes.
•
• Check drain hose installation.
E2
• Lock - error. • Shut the door properly.
E4
• Water level not reached after 10
minutes. at the latest.
Drain hose is self-syphoning.
• Make sure that tap is fully opened and water
Pressure is normal.
• Check drain hose installation.
E8
Water protective level - error. •
•
•
Contact the After sales service.
F3
•
•
Temperature sensor - error. Contact the After sales service.
F4
• Heating error.
Contact the After sales service.
of a problem please check all shown possibilities and follow below instructions before you
contact an after sales service. See CUSTOMER SERVICE.
WARNING!
▶ Before maintenance, deactivate the appliance and disconnect the mains plug from
the mains socket.
▶
improper repairs can cause considerable consequential damages..
▶ A damaged power cable should only be replaced by the manufacturer, its service
9.1 Information codes
Following codes are displayed only for information referring to the washing cycle.
Code Message
1:25
The remaining wash cycle time will be 1 hour and 25 minutes.
6:30
The remaining wash cycle time including chosen end-time delay will be 6 hours and 30 min-
utes.
End
cLo1-
Function child lock is activated.
LocI-
Door is closed because of high water level, high water temperature or spinning cy-
cle.
bEEP OFF
The buzzer is deactivated.
bEEP ON
The buzzer is activated.
To Next Page
Loading...
Need help?
General
