10-Installation
GB
28
10.8 Electrical Connection
Before each connection check if:
▶ power supply, socket and fusing are appropriate to
the rating plate.
▶ the power socket is earthed and no multi-plug or
extension are used.
▶ the power plug and socket are strictly according.
▶ Only UK: The UK plug meets BS1363A standard.
Put the plug into the socket (Fig. 10-8).
10-8
WARNING!
▶
dry and leak free!
▶ Take care these parts are never to be crushed, kinked, or twisted
▶ If the supply cord is damaged, it must be replaced by the service agent (see warranty
card) in order to avoid a hazard. .
Note: Hygiene
-
tenance run programme Cotton 90°C with no load and small amount of detergent in
washing agent compartment (2) or with special machine cleaner to remove possibly
residues.
10.7 Fresh Water Connection
10-7.210-7.1
Make sure that the gaskets are inserted.
1. Connect the water inlet hose with the angled end
to the appliance (Fig. 10-7.1). Tighten the screw
joint by hand.
2. The other end connect to a water tap with a 3/4“
thread (Fig. 10-7.2).
To Next Page
Loading...
Need help?
General
