What to do if my Haier HWD80-BP14636N Washer/Dryer appliance fails to operate?
If your Haier Washer/Dryer fails to operate, consider the following: * Ensure the program has been started. * Check that the door is properly closed. * Verify the machine is switched on. * Check the power supply. * Deactivate the child lock, if it is activated.
What to do if my Haier HWD80-BP14636N shows CLR FLTR error?
If your Haier Washer/Dryer displays a 'CLR FLTR' error, it indicates a drainage issue where water isn't fully drained within 6 minutes. You should: * Clean the pump filter. * Check the drain hose installation.
What to do if my Haier Washer/Dryer is draining incorrectly?
If your Haier Washer/Dryer is draining incorrectly, check the following: * Ensure the drain hose is properly installed. * Make sure the drain hose end is not submerged in water. The height of the drain hose should not be below 80 cm.
What to do if my Haier HWD80-BP14636N Washer/Dryer operation stops before completing wash cycle?
If your Haier Washer/Dryer stops before finishing the wash cycle, check both the power and water supply.
What to do if my Haier Washer/Dryer spinning fails?
If the spinning cycle fails in your Haier Washer/Dryer, it might be due to an unbalanced laundry load. Check the machine load and laundry distribution, then run the spinning program again.
What to do if my Haier HWD80-BP14636N has a drainage failure?
To solve drainage failure of your Haier Washer/Dryer, unblock the drain hose.
What causes excessive foam in my Haier HWD80-BP14636N?
Excessive foam in your Haier Washer/Dryer can be caused by: * Using an inappropriate detergent. * Using too much detergent. To fix this: * Check detergent recommendations. * Reduce the amount of detergent used.
What does it mean if my Haier HWD80-BP14636N operation stops for a period of time?
If your Haier Washer/Dryer pauses, it could be due to: * An error code being displayed. * A problem with the load pattern. * The program running a soaking cycle. To address this: * Check the display for error codes. * Reduce or adjust the load. * Cancel the program and restart it.
Why is my Haier HWD80-BP14636N Washer/Dryer showing error code E4?
The 'E4' error code on your Haier Washer/Dryer indicates that the water level was not reached after 8 minutes or the drain hose is self-syphoning. To resolve this: * Ensure the water tap is fully opened and water pressure is normal. * Check the drain hose installation.
Why is my Haier Washer/Dryer showing error code E2?
The E2 error on your Haier Washer/Dryer indicates a lock-error. Make sure the door is shut properly.
General| Type | Washer/Dryer |
|---|---|
| Washing Capacity | 8 kg |
| Drying Capacity | 5 kg |
| Energy Efficiency Class | A |
| Spin Speed | 1400 rpm |
| Noise Level (Washing) | 56 dB |
| Noise Level (Drying) | 62 dB |
| Color | White |
| Programs | 16 |
| Delay Start | Yes |
| Child Lock | Yes |
To Next Page