How to fix a drainage error on my Haier HWD80-B14939S8?
If your Haier Washer/Dryer is showing a drainage error because water isn't fully draining, try cleaning the pump filter. Also, check the drain hose installation to ensure it's properly set up.
What to do if the load is attached to the cylinder wall in my Haier HWD80-B14939S8 Washer/Dryer?
If the load is attached to the cylinder wall in your Haier Washer/Dryer, open the door, shake off the load cloth, and put it back into the inner cylinder to start the machine.
How to remove grey patches from laundry washed in my Haier HWD80-B14939S8 Washer/Dryer?
To address grey patches on laundry after washing in your Haier Washer/Dryer, pretreat the laundry with a special cleaner before washing.
What should I do if my Haier HWD80-B14939S8 Washer/Dryer stops before completing the wash cycle?
If your Haier Washer/Dryer stops before completing the wash cycle, check both the power and water supply to ensure they are properly connected.
How to remove washing powder residues from laundry in my Haier HWD80-B14939S8?
If you notice washing powder residues on your laundry after using your Haier Washer/Dryer, perform an extra rinse cycle. You can also try to brush the residues from the dry laundry or choose a different detergent.
Why is there excessive foam in my Haier HWD80-B14939S8?
If excessive foam is appearing in your Haier Washer/Dryer, check the detergent you're using to ensure it's appropriate for the machine. Also, reduce the amount of detergent you're using.
What to do if water level is not reached after 8 minutes in my Haier Washer/Dryer?
If the water level isn't reached after 8 minutes in your Haier Washer/Dryer, make sure the tap is fully opened and the water pressure is normal. Also, check the drain hose installation.
How to improve unsatisfactory washing results with my Haier HWD80-B14939S8 Washer/Dryer?
If you're not getting satisfactory washing results with your Haier Washer/Dryer, select another program that better suits the degree of pollution. Use detergent according to the degree of pollution and manufacturer's specifications. Reduce the load size, and make sure the laundry is not packed too tightly in the drum.
Why is my Haier HWD80-B14939S8 Washer/Dryer draining while filling?
If your Haier Washer/Dryer is draining water while it's filling, ensure the drain hose is properly installed and that its height is at least 80 cm. Make sure the drain hose is not submerged in water.
What to do if I get an unbalanced load error on my Haier HWD80-B14939S8 Washer/Dryer?
If you are getting an unbalanced load error on your Haier Washer/Dryer, check and balance the laundry load in the drum. Try reducing the load size.
General| Brand | Haier |
|---|---|
| Model | HWD80-B14939S8 |
| Category | Washer/Dryer |
| Language | English |
To Next Page