18
To unlock press the " "
and
case of abrupt power failure or the need to cut o power
resume when the power is on again.
program selector again to choose another
program.
During the spin process, if too much foam is inspected, in order to protect the motor, the
Maintenance
.lennosrep ecnanetniam eht tcatnoC
.lennosrep ecnanetniam eht tcatnoC
Water level sensor error.
rorrE rotoM F7
E8
FA
FC1
FC2
Contact the maintenance personnel.
UNb
Washing machine has an unbalanced load
weight is greater than allowable maximum,
the washing machine will not spin and will
and noise
End
1:25
19:30
End of wash cycle.
1.In case washing 1 piece of laundry(carpet,
bed sheet,table sheet,ect) make it
symmetrical inside the drum.
2.Lower the wet weight of laundry pieces
by wringing manually and placing them
piesces inside the washing machine in a
ofr the drum.
4.Add 1 or 2 pieces of laundry into the durm
to reduce the unbalanced load effects.
5.Restart the spin cycle by cloosing spin
programme.In case the failure persists,
please ask a qualified technician to repair it.
.lennosrep ecnanetniam eht tcatnoC
.lennosrep ecnanetniam eht tcatnoC
Temp.
Temp.
Intense
Intense
board and motor
board and power board
6.Select a lower spin speed, and if OK then
select Spin program and a higher spin speed.
knobs.
To Next Page
Loading...
Need help?
General
