1. Remove the packing material and packaging tape
Remove the all packing materials and packaging tapes for transportation.
2. Check out standard attachments
Please check out the articles in cabinet
according to packing list, if there is any
discrepancy, please contact with after-sales
service department.
3. Placing conditions
Leave at least 30cm gap around
refrigerator-freezer for ventilation and heat
dispersion.
Take our two metal foot in shape of “几”, and
four attached screws from cabinet drawer, fix
the foot in holes at back board outside cabinet,
so as to avoid contacting with wall directly.
4. Adjust bracing foot
Bracing foot has been adjusted to proper
height before delivery, if it is needed, rotate
level supporting foot in clockwise by wrench to
enable it stretch out, and support on ground,
make sure the balance and stability of
refrigerator-freezer.
5. Standing
After placing and leveling, cleaning machine
body, don't power on. Stand for more than 24h
before power on, and make sure the normal
operation of refrigerator-freezer.
21
8
Use fork truck or clip package car to move refrigerator-freezer before unwrapping. If fork truck is
used to move refrigerator-freezer, it should be inserted at bottom of wooden base from front or
back. If clip package car is used, it can only clip from bottom of wooden base at side face.
Trundle can be used to move the cabinet after removing package.
The inclination angle of cabinet should not be greater than 45° during moving.
Stop refrigerator-freezer
If refrigerator-freezer needs to stop working for a long time, you should cut off power and turn the
power switch to “O”;
Open refrigerator-freezer door, and take the inner shelf out;
Completely clear the refrigerator-freezer;
Clear the shelf;
When the refrigerator-freezer and shelf are dry, put shelf back into refrigerator-freezer;
Close the cabinet door, and put a plastic bag for sealing.
Battery maintenance
1. For continuous power on of equipment, please inspect battery power every 15 days (See P17 for
inspection method, alarm test function), in case of low battery, make sure the battery switch is
turned on, then the battery will be charged, after continuous charging for a week, please retest
battery power, which should be full in normal condition, if it is still low battery, the charging battery
should be replaced.
2. Power outage alarm battery is consumable, and battery life is about 3 years, if it is used for over
3 years, it may fail to act in case of alarm, battery should be replaced earlier, and please contacts
Haier after-sales servicer.
If equipment is not used for long time in area without monitoring, please make sure children will not
be close to the equipment, and the door should not be closed fully, the end-of-life disposal of
equipment should be done by corresponding person, to prevent asphyxia accident, make sure to
dismantle the cabinet door .
Preparation before use
Supporting foot
Downward
upward
> 30cm from the top
> 30cm from
the back
> 30cm from
the left
> 30cm from
the right
To Next Page
Loading...
