Haier HYCD-282A - Cleaning and Maintenance; Component Cleaning; Inner wall defrosting; Initial Power-on

20
9
Under the condition of empty cabinet, connect power wire to special socket with proper
specification, and make sure the power supply is 220V/50HZ .
Turn on the charging battery switch of machinery electric cabinet on top of refrigerator-freezer
back (It can be seen from back of refrigerator-freezer), if it is not turned on, there will be low
battery alarm during test, and press buzzer cancel button can clear the alarm.
Set the required temperature: Keep the cabinet empty, boot with electrify, and observe normal
on-off of refrigerator-freezer for over 24h, certifying the normal performance.
After a period of running, the temperature of refrigerator-freezer will be stable at setting value.
When the operation of refrigerator-freezer is completely checked, gradually put articles in
cabinet.
Observe the rules below for initial start-up and continuous operation:
Initial Power-on
Inner wall defrosting
The frost is generally close to door seal in cabinet, and frost may result in gap between cabinet and
door seal, causing bad cooling effect, use attached shovel to defrost, the following steps are for
defrosting by moving empty cabinet.
Take out the cabinet articles to other equipment;
Turn off power switch;
Open cabinet door for a period of time to defrost;
Dry the water at bottom of cabinet by a dry cloth;
Restart equipment after cleaning cabinet body;
Put articles back when the cabinet is fully cooled.
If only freezing chamber needs to defrost, you can press defrost key on display board, the operation
method is, long press defrost key for 5s after unlocking keyboard, the refrigeration system of
freezing chamber will stop working. After defrosting, manually press defrost key for 5s again to
deactivate defrost mode, the refrigeration system of freezing chamber will restart.
Refrigerator-freezer should be cleaned once a month. Regular cleaning to make
refrigerator-freezer to keep brand new appearance.
Wipe the dust on refrigerator-freezer shell, inner room and all attachments by dry cloth. If the
refrigerator-freezer is very dirt, clean it by cleaning cloth soaked in neutral detergent, and wipe the
residual detergent by wet cloth, then dry cloth.
Don't pour water on refrigerator-freezer shell or interior, or it may damage appliance insulation and
cause failure.
Compressor and other mechanical parts are in completely seal status without lubrication.
Don't use knife, screw driver and other shape edged tools to defrost.
Cleaning and Maintenance
Component Cleaning
To prevent electric shock or personnel injury, make sure to cut off
refrigerator-freezer power before any repair.
Be sure not to breath in drug or suspended particle around refrigerator-freezer
during maintenance, or it may affect your health.
Cleaning