16 49-1000557 Rev. 0
ACCESSORY
ENGLISH
YOU WILL NEED
BEFORE YOU BEGIN
Read these instructions completely and carefully.
WARNING
ELECTRICAL
SHOCK HAZARD To eliminate the risk of
electric shock or injury during installation,
you must first unplug the refrigerator before
proceeding.
Flat blade and Phillips
screwdrivers
Pliers
Sharp knife
PREPARE THE REFRIGERATOR
Inside of the
freezer, remove
the cover for the
icemaker power
supply socket.
SET POWER SWITCH TO OFF
Set the icemaker power switch to OFF.
Power
Switch
(Appearance may vary)
INSTALL THE ICEMAKER FILL CUP
Install the icemaker
fill cup (13) into the
icemaker as shown.
Cover for
icemaker
socket
PLUG IN THE ICEMAKER
Plug the icemaker power cord into the socket making sure
the prongs and holes are matched. Press the plug firmly
into the socket. Lock the plug in
place by clipping the restraints
into each side of the plug. Make
sure the restraints click into
place. Make sure the power cord
is still in the hook on back of the
icemaker.
Hook
MOUNT THE ICEMAKER
• For easy installation, remove the top and middle left
freezer drawer
• Drive both mounting screws halfway into screw holes
on the support bracket of the left side upper wall in the
freezer. Lift the icemaker so the fill tube assembly fits in
the fill cup opening. Hang the icemaker on the screws
and on the L-shaped tab in front of the supporting
bracket.
Make sure:
• The power cord is still firmly in the socket.
• The fill tube assembly extends into the fill cup opening
at the back of the icemaker.
• The icemaker mounting screws should be located in
the uppermost position of the mounting slots on the
icemaker bracket.
• The icemaker is level.
• The icemaker power switch is in the OFF position.
SECURELY TIGHTEN THE ICEMAKER MOUNTING
SCREWS.
Mounting
screws
L-shaped
tab
Fill cup
Fill tube
Icemaker
support
bracket
READ AND SAVE THESE INSTRUCTIONS
To Next Page
Loading...
Need help?
General
