Indoor Unit Installaion
Driver
Torque wrench
(17mm,22mm,26mm)
Nipper
Reamer
Hacksaw
Pipe cutter
Gas leakage detector or
soap-and-water solution
Hole core drill
Flaring tool
Spanner(17,19 and 26mm)
Knife
Measuring tape
Necessary Tools for Installation
Power Source
Before inserting power
into receptacle, check the voltage without
fail.
The power
supply is the same as the
corresponding nameplate.
Installanexclusivebranchcircuitofthepower.
Areceptacleshallbesetupinadistancewherethepowercable
can
be
reached.
Do not extend the cable by cutting it.
Selection of Installation Place
Place, robust not causing vibration, where the body can be
supported suff ciently.
Place,notaffectedbyheatorsteamgeneratedinthevicinity,
where inlet and outlet of the
unit are not disturbed.
Place, possible to drain easily, where piping can be conne-
cted with the outdoor unit.
Place,wherecoldaircanbespreadin a roomentirely.
Place, nearby a power receptacle, with enough space around.
Placewherethedistanceofmorethanlmfromtelevisions,
radios, wireless appara tuses
a
nd fluorescent lamps can be
left.
In the case of fixing the remote controller on a wall, place
where the indoor unit can
receive signals when the fluore-
scent
lamps
in the room are lightened.
Thedistancebetween
the indoor unit and the
floor should be more
than 2m.
ThemodelsadoptHFCfreerefrigerantR410A
more than
10cm
more than 15 cm
more than 10cm
Arrangement of piping
directions
Rear left
Left
Rear
right
Right
Below
Attention must be paid to
the rising up of drain hose
Remote controller (1)
R-03 dry battery (2)
Mounting plate (1)
Drain hose (1)
Ø4X25 Screw
(4)
Plastic cap (4)
Accessory Parts
FOR 09K 12K
FOR 18K
FOR 24K
Selection of Pipe
Drawing for the installation of indoor units
Air purifying filter(Optional) (1)
Please be subject to the actual product purchased,the above picture is just for your reference.
System configuration
36
Domestic air conditioner
To Next Page
Loading...
