Why is my Haier WD-8888-19 making abnormal sounds and vibrating violently during spinning?
Abnormal sounds and violent vibration during spinning can occur for several reasons: * The spinning might be overloaded. * The gland might not be pressed in evenly. * The laundries might be put in slantingly. * The machine might not be located on even ground. Ensure the machine is on even ground and that the gland is pressed in evenly.
What to do if my Haier Washer drainage does not work?
If the drainage isn't working, consider the following: * Check if laundries have fallen into the spinning tub. * Inspect the front of the drain hose for blockages. * Make sure the button is set to the 'Drain' position.
Why is the spinning on my Haier WD-8888-19 Washer not working or slow?
If the spinning isn't working or the spinning speed is slow, check if the spinning tub cover is closed and whether the axle of the spinning tub is twisted with the laundries.
What to do if the motor of my Haier WD-8888-19 Washer does not rotate?
If the motor isn't rotating, check these things: 1. Make sure the power is on. 2. Check if the power plug is properly inserted. 3. Remove any hairpins, coins, or metal objects from the washing tub.
Why Haier WD-8888-19 pulsator rotates to one direction only?
To address the issue of the pulsator rotating in only one direction, release the washing timer.
How to place the washing machine in its designated location.
Ensuring the machine is stable on uneven ground.
Importance and method of grounding the machine.
Proper installation and use of the drain hose.
Proper connection of the water inlet hose to prevent leakage.
Troubleshooting steps specific to the washing function of the machine.
Troubleshooting steps specific to the spinning function of the machine.
Diagnosing and resolving rubbing sounds during the braking process.
Identifying causes for loud noise during the washing cycle.
Addressing the pulsator rotating in only one direction.
Addressing common issues and their potential reasons before sending for repair.
Guidelines for safe and correct disassembling/assembling procedures.
Steps for removing and reassembling the control panel.
Procedure for disassembling the spinning tub frame.
Steps to remove and reassemble the spinning tub.
How to adjust the belt tension for proper operation.
Steps to disassemble and reassemble the base frame.
Procedure for replacing the bearing seat, including safe installation of new parts.
To Next Page
General