What to do if my Haier HW100-B14979 Washer fails to operate?
If your Haier Washer fails to operate, several factors could be at play. First, ensure that you've started the programme correctly and that the door is securely closed. Then, verify that the machine is switched on and that there is no power failure. Finally, check if the child lock is activated and deactivate it if necessary.
Why is my Haier HW100-B14979 Washer vibrating so much while spinning?
If your Haier Washer is experiencing strong vibrations while spinning, make sure to remove all transportation bolts. Also, ensure the appliance is on solid, level ground and that the machine load is properly balanced.
How to fix drainage failure in Haier HW100-B14979 Washer?
To resolve drainage failure in your Haier Washer, first, check the drain hose for any blockages and clear them. Also, make sure that the drain hose end isn't higher than 100 cm above the floor.
How to remove washing powder residues from laundry after washing in Haier HW100-B14979?
If you see washing powder residues on the laundry after washing in your Haier Washer, try performing an extra rinse. You can also brush the spots from the dry laundry or choose another detergent.
How to fix Heating system error on Haier HW100-B14979?
To fix a heating system error on your Haier Washer, check the heater and wire connection. The resistance of heater should be around 30.
What does error code 'E4' mean on my Haier HW100-B14979 Washer?
If your Haier Washer displays 'E4', it means the water level was not reached after 12 minutes or the drain hose is self-syphoning. Make sure that the tap is fully opened and the water pressure is normal. Also, check the drain hose installation.
What does CLR FLTR mean on my Haier HW100-B14979?
If your Haier Washer is displaying 'CLR FLTR', it indicates a drainage error where water isn't fully drained within 6 minutes. Check the drain hose installation.
What to do if Sub-switch continuously leaks for 10 seconds-error in Haier HW100-B14979 Washer?
If the sub-switch continuously leaks for 10 seconds (error) in your Haier Washer, open drain pump to drain and shut down the machine.
Why is my Haier HW100-B14979 control panel out of function?
If the control panel of your Haier Washer isn't working, it might be because the child lock is activated. Try deactivating the child lock.
Why is my Haier HW100-B14979 Washer spinning failing?
Spinning may fail in your Haier Washer because of an unbalance of laundry. Check the machine load and laundry, then run a spinning programme again.
Essential safety advice for first use, daily operation, and appliance handling.
Safety rules for operating the machine, cleaning, and maintenance tasks.
Safety guidelines for appliance installation, environmental conditions, and intended use.
Detailed illustration and labeling of the washing machine's front and rear parts.
List and illustration of accessories provided with the washing machine.
Overview of the power button, programme selector, and display functions.
Details on the detergent drawer and various function buttons like Delay, i-time, Temp.
Explanation of Start/Pause button, Speed, Extra Rinse, Steam, Stain removal, and Child Lock.
Table detailing various wash programmes, load capacities, and fabric types.
Overview of optional functions like i-time, Steam, Delay, and Stain removal for programmes.
Table detailing energy, water, and time consumption for different programmes.
Explanation of how the appliance adjusts settings based on load weight.
Instructions for connecting the appliance to power and water supply.
Advice on sorting, preparing, and loading laundry for washing.
Guidance on choosing detergents and adding them to the machine.
Steps for switching on, selecting programmes, adding options, and starting the wash.
How to start, pause, cancel washes, post-wash actions, and manage buzzer settings.
Advice on using energy, water, and detergent efficiently.
Detailed instructions for cleaning the detergent drawer, machine exterior, water inlet filter, and drum.
Procedures for long periods of disuse and cleaning the pump filter.
Explains information codes and guides on resolving display error codes.
Addresses problems like machine not operating, water filling, draining, and vibration.
Solutions for foam, washing results, residues, and recovering from power failures.
Unpacking, noise pad installation, and removing transportation bolts.
Guidance on moving the appliance and adjusting feet for level positioning.
Instructions for connecting the drain hose, water inlet hose, and electrical plug.
Technical specifications and consumption data as per EU regulations.
Details on dimensions, power, pressure, weight, and compliance standards.
Information on how to get help, find FAQs, and activate service claims.
List of Haier customer service addresses across various European countries.
General| Door color | Black |
|---|---|
| Door hinge | Left |
| Motor type | Beltless |
| Water fill | Cold |
| Control type | Rotary, Touch |
| Display type | LED |
| Loading type | Front-load |
| Tub material | Plastic |
| Drum material | Stainless steel |
| Product color | White |
| Built-in display | Yes |
| Custom panel-ready | - |
| Illumination color | Blue |
| Appliance placement | Freestanding |
| Drum capacity | 10 kg |
| Cycle time (max) | 238 min |
| Delay start (max) | 24 h |
| Spin-drying class | B |
| Maximum spin speed | 1400 RPM |
| Noise level (spin) | 69 dB |
| Noise level (wash) | - dB |
| Number of washing programs | 14 |
| Maximum washing temperature | 90 °C |
| Power plug type | Type F (CEE 7/4) |
| AC input voltage | 220 - 240 V |
| Energy efficiency scale | A to G |
| Power consumption (standby) | 0.45 W |
| Water consumption per cycle | 51 L |
| Energy consumption washing per cycle | 0.512 kWh |
| Package depth | 646 mm |
| Package width | 653 mm |
| Package height | 890 mm |
| Package weight | 82000 g |
Weight and Dimensions| Depth | 620 mm |
|---|---|
| Width | 590 mm |
| Height | 850 mm |
| Weight | 77000 g |
To Next Page
