Why is my Haier HW100-BP14929 not starting?
Your Haier Washer might not start due to several reasons: the program hasn't been started yet (check and start it), the door isn't properly closed (close it properly), the machine hasn't been switched on (switch it on), there's a power failure (check the power supply), or the child lock is activated (deactivate it).
Why is my Haier HW100-BP14929 Washer vibrating so much during spinning?
Strong vibrations during spinning can occur if not all transportation bolts have been removed (remove them), the appliance doesn't have a solid position (ensure solid ground and a leveled position), or the machine load is incorrect (check load weight and balance).
How to fix drainage failure in my Haier HW100-BP14929?
If your Haier Washer is experiencing drainage failure, it could be due to a blocked drain hose (unblock it) or the drain hose end being higher than 100 cm above floor level (ensure the drain hose is properly installed).
Why is my Haier HW100-BP14929 not washing clothes properly?
The washing result may be unsatisfactory if the degree of pollution does not match the selected program (select another program), the detergent quantity was insufficient (choose the detergent according to the degree of pollution and manufacturer's specifications), the maximum load has been exceeded (reduce loading), or the laundry was unevenly distributed in the drum (loose the laundry).
What to do if my Haier Washer is not filling with water?
If your Haier Washer isn't filling with water, check the following: ensure the water tap is open, inspect the inlet hose for kinks, verify that the water pressure is at least 0.03 MPa, make sure the door is properly closed, and ensure there isn't a water supply failure.
What to do if my Haier HW100-BP14929 stops mid-cycle?
If your Haier Washer stops before completing the wash cycle, check the power and water supply, as it could be due to a water or electric failure.
Why is my Haier Washer draining immediately?
Your Haier Washer might be draining immediately if the height of the drain hose is below 80 cm (ensure it's properly installed) or if the drain hose end is reaching into water (make sure it's not in water).
How to prevent excessive foam in my Haier HW100-BP14929 Washer's detergent drawer?
Excessive foam in the detergent drawer can be caused by using an inappropriate detergent (check detergent recommendations) or using too much detergent (reduce the amount).
Why is my Haier HW100-BP14929 showing the error code CLR FLTR?
The CLR FLTR error code on your Haier Washer indicates a drainage error, meaning water is not fully drained within 6 minutes. Check the drain hose installation.
Why is my Haier HW100-BP14929 showing error code E4?
The E4 error code on your Haier Washer means the water level wasn't reached after 12 minutes. This can happen if the tap isn't fully opened and the water pressure is not normal, or if the drain hose is self-syphoning. Check that the tap is fully opened with normal water pressure and check the drain hose installation.
General| Loading type | Front loading |
|---|---|
| Capacity | 10 kg |
| Spin Speed | 1400 rpm |
| Color | White |
| Energy efficiency class | A+++ |
| Water Consumption | 52 L |
| Type | Front Load Washer |
To Next Page