Why is my Haier Washer not filling with water?
If your Haier Washer won't fill with water, check the water tap and ensure there is a water supply. Inspect the inlet hose for kinks and unblock the inlet hose filter if necessary. Also, check the water pressure and make sure the door is properly closed.
Why is my Haier HW100-BD14979U1 vibrating so much during spinning?
If your Haier Washer is vibrating strongly while spinning, remove all transportation bolts and ensure the appliance has a solid and leveled position. Check the load weight and balance.
What causes spinning to fail in a Haier HW100-BD14979U1 Washer?
If spinning fails in your Haier Washer, check the machine load and laundry, then run a spinning program again. This is often caused by an unbalance of laundry.
What to do if my Haier Washer is leaking?
If your Haier Washer is leaking, open the drain pump to drain the water and then shut down the machine. Contact the After sales service.
How to fix a Haier HW100-BD14979U1 that fails to operate?
If your Haier Washer fails to operate, first check if the program has started and start it if needed. Ensure the door is properly closed and that the machine is switched on. Verify the power supply and deactivate the child lock if it's activated.
What to do if my Haier Washer is draining while filling?
If your Haier Washer is draining while filling, ensure the drain hose is properly installed and that its height is not below 80 cm. Also, make sure the drain hose end is not in water.
How to fix drainage failure in Haier HW100-BD14979U1?
If your Haier Washer experiences a drainage failure, unblock the drain hose and clean the pump filter. Ensure the drain hose is properly installed and that its end is not higher than 100 cm above the floor level.
How to resolve a drainage error in Haier HW100-BD14979U1?
If your Haier Washer experiences a drainage error where water is not fully drained within 6 minutes, clean the pump filter and check the drain hose installation.
What to do if Haier Washer stops before completing wash cycle?
If your Haier Washer stops before completing the wash cycle, check the power and water supply.
Why does my Haier HW100-BD14979U1 operation stop for a period of time?
If your Haier Washer operation stops for a period of time, consider display codes. Reduce or adjust the load, or cancel the program and restart it. This issue can arise due to the load pattern or if the program is performing a soaking cycle.
Highlights critical risks of injury or suffocation related to appliance use.
Covers essential safety measures before first use and during daily operation.
Details safe practices for installation, maintenance, and cleaning.
Specifies installation conditions and the intended domestic use of the appliance.
Step-by-step guide for adding detergent and powering on the appliance.
Covers selecting programs and adjusting individual wash options.
Explains how to start, pause, interrupt, and cancel wash programs.
Lists codes displayed during operation and their meanings.
Provides solutions for common problems indicated by specific error codes.
Addresses issues like failure to operate, not filling, or draining while filling.
Solutions for strong vibration, unbalanced loads, and operation stops.
Details how to unlock the door in case of a power failure.
Details on connecting the drain hose to a sink or waste water pipe.
Instructions for connecting the water inlet hose to the appliance and tap.
Essential checks for power supply, socket, and plug before connecting the appliance.
To Next Page
General