Haivision Makito X4 User Manual

www.haivision.com
Makito X4 Decoder 1.3.1
Makito X4 Decoder Quick Start Guide
1
Generated on:2024-02-19 21:08:24
HVS-ID-QSG-MX4D-131, Issue 01
•
•
•
•
•
•
•
•
•
•
•
•
•
Makito X4 Decoder Quick Start Guide
Makito X4 Decoder
This Quick Start Guide providesthe stepsrequired to install andget started configuring the Makito X4
decoder to set up video decoding from a Haivision encoder (Makito X4, Makito X, or Makito “Classic”) or
a third party compatible encoder.
For detailed configuration and operation information, please refer to the User's Guide (available at
https://doc.haivision.com ) .
For the default credentials, refer to the Important Notice document (postcard shipped with the
appliance or available on the Haivision Support Portal at http://support.haivision.com).
For information on the MB6 (6-slot) or MB21 (21-slot) chassis,refer to theMB6 Chassis Installation
Guide or the MB21 Chassis Installation Guide.
Guide Contents
Install the Decoder
Connect to the Network
Connect to A/V Displays
Power Up the Decoder
Access the Web Interface
Set Up Streams
Configure Decoder Outputs
Start to Decode
Safety Guidelines
Laser Safety With SFP+ Optical Modules

Haivision Makito X4 Specifications

General

Video Inputs	4 x 3G-SDI, 4 x HDMI 2.0
Video Outputs	4 x 3G-SDI, 4 x HDMI 2.0
Resolutions	Up to 4K UHD (3840 x 2160)
Latency	< 100 ms
Video Codecs	H.264, H.265
Audio Codecs	AAC, PCM
Protocols	RTMP, RTSP, SRT
Network Interface	2x 10/100/1000 Ethernet
Power Supply	100-240V AC, 50-60Hz
Dimensions	1U Rackmount
Operating Temperature	0°C to 40°C
Storage Temperature	-20°C to 70°C
Chassis	1RU

Summary

Install the Decoder

Before You Begin

Guidelines for safe operation and handling of sensitive equipment before installation.

Connect to the Network

Network Connection

Instructions for connecting the decoder's network port using an Ethernet UTP cable.

Connect to A/V Displays

Video Output Configurations

Details on supported video decoding capabilities and output modes (UHDp60, UHDp30, 1080p60).

Power Up the Decoder

Power Supply and Connection

Steps to connect the power supply and power on the Makito X4 decoder.

Access the Web Interface

Initial Login and Settings

How to access the decoder's web interface using default IP and credentials.

Set Up Streams

Creating and Configuring Streams

Guide to creating streams, selecting protocols, types, and ports.

Configure Decoder Outputs

Adjusting Decoder Settings

Steps to expand configuration panels and adjust input, video, and metadata settings.

Start to Decode

Initiating Video Decoding

Instructions on starting the stream and viewing video on decoder displays.

Safety Guidelines

Antistatic Precautions

Measures to prevent damage from electrostatic discharge (ESD) during handling.

EMC Warnings

FCC and Canadian Compliance

Notices regarding Class A digital device compliance with FCC and Canadian regulations.

CISPR32 Safety Instructions

Safety advice for Class A products concerning potential domestic radio interference.

Laser Safety With SFP+ Optical Modules

Laser Radiation Hazards

Warnings about invisible laser radiation from SFP+ ports and fiber cables.

Getting Help

Contact Information

Provides contact details for general support, managed services, and product information.