Instruction manual
●
PACKING LIST
The
nozzle changer
can be attached to
both sides of the iron stand.
The nozzle assembly have a groove.
Catch the groove with the metal fitting of the nozzle changer.
When the soldering iron is pulled, the nozzle assembly is
removed from the soldering iron.
Pull straight out
along the axis of the
soldering iron.
●
OPERATION
CAUTION
The nozzle assembly after use is hot. Be careful for burns.
Do not leave the soldering iron in the nozzle changer for extended
time while the power is ON.
使用說明書
●
組裝
N2噴嘴更換器可安裝在焊鐵座
的左右兩側。
噴嘴組件具有凹槽。
凹槽部分卡住噴嘴更換器的金屬配件上。
拉動焊鐵時，可將噴嘴組件從烙鐵上取下。
請沿焊鐵軸向上拔出。
●
使用方法
注意
使用後的噴嘴組件溫度會昇高， 請勿接觸, 注意燙傷。
接通電源時，注意不要將焊鐵長時間放在噴嘴更換器上。
B5256
N
2
NOZZLE CHANGER
B5256
N
2
NOZZLE CHANGER
●
INITIAL SETUP
Groove
凹槽
SEMS screw P2
N2
nozzle changer
SEMS screw P2 (M3×6)
Instruction manual
.......................................1
.............................2
......................................1
N2
nozzle changer
Instruction
manual
THERMAL WIRE STRIPPER
FT-802
●
包裝清單
墊圈螺釘 P2
N2噴嘴更換器
墊圈螺釘 P2 (M3×6)
使用說明書
..............................................1
..................................2
..................................................1
N2噴嘴更換器
使用說明書
THERMAL WIRE STRIPPER
FT-802
To Previous Page
Loading...
