EasyManua.ls Logo

Halfords 414734 - Connecting the Coolbox; DC Power Connection; AC Power Connection

Halfords 414734
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
9
5 Connecting the Coolbox
WARNING! DC power supply cable.
The manufacturer does not recommend using any type of 12/24V DC extension cord.
Under no circumstance should an extension to the power cable be attempted by splicing the
cable wires.
Do not use vehicle multisockets or splitters with this product.
Always unroll or uncoil the DC power supply cable fully to avoid heat build up, retention and
possible melting.
When connecting to a battery (vehicle or boat), the coolbox can be operated with12V or
24V DC.
NOTICE! Danger of damage!
Disconnect the coolbox and other powered devices from the battery before you connect the
battery to a battery charger.
Over-voltage can damage the electronics of the coolbox.
For safety reasons, the coolbox is equipped with an electronic system to prevent damage
caused by reversed polarity connection. This protects the device against short-circuiting when
connecting to a battery.
5.1 Using the Fused DC Plug for Coolbox Connection.
NOTICE! Danger of damage!
To protect the coolbox, the DC power supply cable supplied includes a fuse inside the plug. Do
not remove the fuse from the DC plug. Only use the DC cable supplied with the coolbox.
Plug the DC power supply cable into the coolbox DC power supply input.
Connect the DC power supply cable to the DC output socket in the vehicle.
5.2 Connection to an AC Power Supply.
Plug the DC power supply cable into the coolbox DC power supply input.
Connect the DC power supply cable to the DC output socket of an AC adaptor.
Connect the AC power supply cable of the AC adaptor to the AC power supply outlet.
NOTICE! Danger of damage!
Only use an AC adaptor rated to the input of the coolbox.
Never handle electrical plugs and switches with wet hands or if you are standing on a wet
surface.
When using an AC mains supply, it is advisable to use a residual current device (RCD) between
the AC power supply and the coolbox. If in doubt, seek advice from a qualied electrician.
HAL4345_80142_414734 - Halfords 30L Compressor Coolbox - Manual.indd 9HAL4345_80142_414734 - Halfords 30L Compressor Coolbox - Manual.indd 9 25/01/2021 13:2825/01/2021 13:28