710-0133 HM 46 57 Hallmark Manual Date: 06/24/16
Rev 04 Page 8 of 13
ELECTRICAL / HEATER ASSEMBLY
Step 1: Mount the CB-PK-1 contactor box to the
right wall with 4 screws provided by locating the
lower left corner of the box to wood pencil trim
on wall.
Step 2: Mount the sauna heater according to the
Installation and Operation Manual provided with the
heater. The wall is labeled and predrilled for the top
lag screws from the sauna heater hardware.
Step 3: Connect wires from building electrical
supply to the lower terminal block labeled L1,
L2, and Gnd.
Connect wires from sauna heater to upper
terminal block labeled T1, T2, and Gnd
Step 4: Connect all the quick connections according to
the picture and installation manual into the CB-PK
Box.
1- Radio Power (from wall to terminal block in
box)
2- High Limit (from heater to PCA)
3- Room Temp Sensor (from wall to PCA)
4- Color Therapy Lights (from wall to PCA)
5- Control (from wall to PCA)
6- Interior Lights (from wall to transformer in
box)
Bottom of heater
guard location
To Next Page
Loading...