Haltech IQ3 User Manual

Haltech Engine Management Systems
(A division of Lockin P/L, A.B.N. 68 061 744 303)
HEAD OFFICE: 3 Centre Place, Wetherill Park NSW 2164 Australia
t. +61 2 9729 0999 f. +61 2 9729 0900
Haltech IQ3 Quick Start
This guide is designed as a quick start guide to connecting and programming your Haltech IQ3 Dash. Only basic functions
are covered in this guide therefore we recommend you read and familiarize yourself with the RacePak IQ3 Manual as
found on the installation disk included with your Dash.
For Platinum ECUs: Ensure your ECU is running firmware version 1.12 or later and CAN Mode is set to ‘Haltech CAN
(Version 2)’. See the final page of this document for more information.
For Elite ECUs: Ensure your ECU has the ‘Haltech CAN Supported Dash’ function enabled. See the final page of this
document for more information.
Your Haltech IQ3 Dash is pre-programmed with a ‘plug and play’ configuration. You can simply connect the Dash to your
ECU and you’re done.

Haltech IQ3 Specifications

General

Display Type	LCD
Connectivity	CAN
Data Logging	Yes
Backlight	Yes
Alarms	Yes, configurable
Compatibility	Haltech ECUs

Summary

Haltech IQ3 Quick Start

Platinum ECU Prerequisites

Ensure Platinum ECU firmware is v1.12+ and CAN Mode is 'Haltech CAN (Version 2)'.

Elite ECU Prerequisites

Ensure Elite ECU has 'Haltech CAN Supported Dash' function enabled.

IQ3 Dash Connection

Connect the Haltech IQ3 Dash to your ECU for a plug and play configuration.

Haltech IQ3 Dash Programming

Download Dash Configuration File

Follow steps to download dash configuration file for editing using RacePak Datalink II.

Read and Save ECU Configuration

Read ECU configuration, ignore notifications, and save the configuration file.

Set Default Configuration

Make the downloaded configuration file your default for the dash.

Selecting Data Channels

Modify Data Channel Display

Change displayed data channels by selecting sensors and configuring parameters in RacePak software.

Understanding EFI Channel Naming

Haltech channels are labeled with an 'EFI' prefix for identification.

Configuring Dash Layout

Configure Display Segments

Choose channels for each segment, configure filtering, decimal places, and text values.

Configure LED Warning Lights

Configure 4 LED warning lights with channels, limits, text, and trigger conditions.

Configure Internal Shift Lights

Configure internal shift lights for RPM triggers and per-gear limits.

Configuring ECU CAN Mode

Platinum ECUs CAN Mode Setup

Configure Platinum ECUs to broadcast CAN stream using Haltech ECU Manager Software.

Elite ECUs CAN Mode Setup

Configure Elite ECUs to broadcast CAN stream using ESP software.