Notes
PLATINUM
Pro Plug-in Hyundai Genesis BK Theta
Quick Start Guide
Congratulations on purchasing a Haltech Engine Management System.
This fully programmable Plug and Play product opens the door to virtually limitless
performance modification and tuning of your vehicle. Programmable systems allow you
to extract all the performance from your engine by delivering precisely the required
amount of fuel and ignition timing that your engine requires for maximum output under
all operating conditions.
This quick start guide will walk you through installation of the Platinum Pro ECU into
a vehicle. This guide is accompanied by the full service manual located on the software
CD provided with the ECU that you or your tuner will need to refer to before completing
your installation and configuration. The Manual can also be downloaded from the
Haltech website www.haltech.com
Supported Vehicles
The Platinum Pro Plug-in Hyundai Genesis BK Theta ECU supports the following:
Hyundai Genesis (USA Only) 2.0L turbo Theta engine
(Key start and Push button Start, manual only)
Platinum Pro Plugin Hyundai Genesis BK Theta Kit Includes
• Haltech Platinum Pro Plug-in ECU
• Rear Auxiliary Connector and pins
• USB Cable
• Software CD
• Quick Start Guide
Optional Accessories ( Sold Separately )
• Rear Auxiliary Harness ( HT040003 )
• 3 Bar Map Sensor ( HT010104 )
Loaded Basemap
Your Platinum Pro Plug-in has been programmed with a basemap to suit a
Hyundai Genesis running a Theta 2.0L standard engine with Key Start Option.
Please ensure you load, modify and check the corresponding basemap for your
application and calibrate the Electronic Throttle within ECU Manager software before
attempting to start the vehicle.
To Next Page
Loading...
Need help?
General
