Hama Looptastic - Control Trimming; Actual Direction Mode

11
Loops –only for experienced pilots!
Note –Loops and 360° rolls
• The battery of the drone must be fully charged to be
able to use the loop function.
Right control
• Fly the drone at an altitude of approximately 3m.
• Press the Loop button 1(1) to perform aloop.
• Press the Loop button 2(8) and then move the right
control lever (9) to the left or right to perform a360°
roll sideways.
7.3 Tweaking the control (trimming)
Note –Trimming
• The drone should be smooth and stable in the air,
and should y only in the direction that is set using
the control.
• After acertain time, theremay be slight directional
tilts even though the control levers areinthe resting/
neutral position.
• These directional tilts can be eliminated by trimming
the control.
Left/right
• If the drone continually tilts to the right during the ight,
briey push the Tweaking button (11) to the left. Repeat
this step until the drone is aligned.
• If the drone continually tilts to the left during the ight,
briey push the Tweaking button (11) to the right.
Repeat this step until the drone is aligned.
Forwards/backwards
• If the drone continually tilts forwards during the ight,
briey push the Tweaking button (10) downwards.
Repeat this step until the drone is aligned.
• If the drone continually tilts backwards during the ight,
briey push the Tweaking button (10) upwards. Repeat
this step until the drone is aligned.
7.4 Actual Direction mode
Note –Actual Direction mode
• If Actual Direction mode is activated, the control of
the drone when sending commands is guided by the
position of the pilot.
• If you move the right control lever (9) upwards/
downwards, the drone ies away from you /towards
you.
• If you move the right control lever (9) to the left/right,
the drone ies left/right.
• The ight direction and position of the drone is
irrelevant in this mode.
• Make surethat you remain in the position that you
take during calibration with the remote control.