Hama RC200 - Alarm and Display Settings; Alarm Configuration and Control; Display Format Selection

7
• Press and hold the ▲ button (13) for approx. 3 seconds until the time zone symbol
F
is displayed.
• Press and hold the MODE button (11) for approx. 3 seconds to set the required time zone difference.
• To select the individual values, press the ▲ button (13) or the  button (12) and conrm each selection by
pressing the MODE button (11).
• Press and hold the ▲ button (13) for 3 seconds to switch the display between local and time zone-shifted
time.
Selecting 12 or 24-hour format
• Press the ▲ button (13) to switch between the 12 and 24-hour formats.
5.3. Temperature display
• Press the °C/°F/WAVE button (10) to choose between °C and °F for the temperature display (8).
5.4. Alarm
Note – Alarm
The alarm time always depends on the time displayed, that is, the local or time zone-shifted time (
F
).
Setting the alarm time
• Repeatedly press the MODE button (11) to access alarm mode 1 (ALM1) or 2 (ALM2).
• Press and hold the MODE button (11) to set the alarm time (8) for the alarm displayed. The hours display
begins to ash.
• Press the ▲ button (13) or the  button (12) to select the hour for the alarm time and conrm your
selection by pressing the MODE button (11). The minutes display begins to ash.
• Repeat the process to set the minutes for the alarm time.
• Press the MODE button (11) repeatedly to also set the other alarm mode or return to the temperature
display.
Activating/deactivating the alarm
• Press the ALARM button (9) repeatedly to activate/deactivate alarm 1 or alarm 2.
• If an alarm is activated, the corresponding symbol
1
/
2
will be displayed.
Stopping the alarm/snooze function
• If the alarm is triggered, the alarm symbol
1
/
2
will begin to ash and an alarm will sound.
• Press the ALARM button (9) to stop the alarm. Otherwise, it will stop automatically after 4 minutes.