Hama SIRIUM4000ABT User Manual

12
12. Alexa function (voice control)
• After you have said the wake word(‘Alexa’) or pressed
the [Action / Microphone mute]button (3), the Alexa
status LED (11) is lit blue and asignal tone sounds. You
can now speak with Alexa.
• The Alexa status LED (11) ashes blue while Alexa
answers.
Note -Alexa Push to talk/function key
• Brieypress the [Action /Microphone mute] button
(3) on the soundbar to activate Alexa during audio
operation or high volume. Alternatively,press the
Action button (3) on the remote control.
• Press and hold the [Action /Microphone mute] button
(3) for about 3seconds to switch off the microphone.
Alternatively,press the [MUTE]button (4) on the
remote control. The soundbar will now no longer
respond to the wake worduntil the microphone is
activated again. If the microphone is switched off,the
soundbar can still be operated using the buttons on
the soundbar or remote control.
13. Positioning in the room
• The soundbar can be mounted above or below the
television. It can also be positioned on furniture. The
subwoofer is placed on the oor near to the television.
Note
• Make surethat the soundbar is set up horizontally.
• To prevent audio quality limitations, the connection
side of the soundbar should always point towards the
television.
• Do not place the soundbar inside acabinet.
14. Equaliser profiles
Youcan choose between three different equaliser modes
for the playback of your audio signals:
• Cinema mode emphasises low and very low frequencies,
as well as trebles. The large dynamic range of spectacular
lm productions is played back impressively.
• In Music mode, all audible frequencies areplayed
back linearly (equally loud) if possible. Nothing is
articially over-orunderemphasised; the behaviour of
the soundbar is neutral. Music sounds just how it was
recorded.
• Voice mode focuses on the human voice, which lies mid-
range in the audible frequency spectrum. Spoken wordis
played back particularly clearly in this mode.
• Press the [CINEMA]button (7) on the remote control to
activate Cinema mode.
• Press the [MUSIC]button (8) on the remote control to
activate Music mode.
• Press the [VOICE]button (9) on the remote control to
activate Voice mode.
15. Bass control
• Press [BASS+/-](5) on the remote control to increase or
reduce the bass of the subwoofer.
• Alternatively,press [MODE](2) and [VOLUME +/-](4)
at the same time to increase or reduce the bass of the
subwoofer.
16. Volume control
• Press [VOLUME +/-](4) on the soundbar to increase or
reduce the soundbar’svolume.
• Alternatively,press [VOL+/-](6) on the remote control or
use the Hama Smart Audio app.
17. Wireless connection (WLAN)
Depending on the network, thereare anumber of ways to
connect to it.
PBC setup
• Press and hold the [WIFI SETUP]button (network
pairing) (5) for about 3seconds.
• The network status LED (5) ashes green.
• Press the WPS button on your router or current access
point. This can often be done using the web interface,
as well.
• Consult the operating instructions of your router or
access point for details.
• Once the process has been started on the router or
access point, the soundbar should be able to nd and
connect to the network.
Note
• Press the [WIFI SETUP]button (network pairing) (5)
to cancel PBC setup.

Hama SIRIUM4000ABT Specifications

General

Brand	Hama
Model	SIRIUM4000ABT
Category	Speakers
Language	English