13
Open/unsecured network
Note
• We recommend against establishing unsecured
connections and advise you to always protect your
network against unauthorised access.
• If your desired network has no safeguards, it is
enough to select the network from the list and
conrm your selection. The soundbar then promptly
connects to the access point.
18. Activate pairing mode /connection to another
home network
• Press and hold the [WIFI SETUP]button (network
pairing) (5) for about 5seconds. The network status LED
(5) pulsates.
• The soundbar can now be connected to anew network
(as described in Section 6.2).
19. Connection between subwoofer and soundbar
(pairing)
• Press and hold the [PAIRING]button on the subwoofer
until the LED light of the subwoofer begins to ash.
• Then press the [PAIRING]button on the soundbar for
about 5seconds. The two devices then connect to one
another automatically.
20. Using your existing remote control
Note –Remote control
• To enable programming, the remote control being
taught must have an infrared transmitter.
• If the remote control has adifferent standard(for
example, Bluetooth), learning is not possible.
• To check the standard: Point the remote control at
your smartphone’scamera. Check the remote control
for light pulses. If thereare light pulses on the remote
control, it is an IR remote control.
Button programming
The soundbar has alearning function. It allows you to
transfer up to three of your soundbar’sfunctions to any
remote control (for example, that of your TV set).
• Press and hold both [VOLUME+/-] buttons (4) on the
soundbar at the same time. Keep them held for about 3
seconds to activate the learning mode. The LEDs on the
soundbar begin to ash quickly.
• On the soundbar,press the button whose function you
want to transfer to abutton on the remote control.
• On the remote control, press the button to be
programmed with the function.
• The LEDs (7), (8) and (9) on the soundbar ash blue to
indicate successful learning. If learning has failed, these
LEDs will ash redthree times.
Note
• The learning process is ended without saving, if no
button is pressed or no signal received for longer than
10 seconds.
Deleting programmed buttons
• Press the [Action / Microphone mute](3), [VOLUME
+]and [VOLUME -](4) buttons at the same time to
delete all buttons with learnt functions.
21. Factory settings
To reset the soundbar to the factory default settings,
proceed as follows:
• Press and hold the [MODE](2), [Action / Microphone
mute](3) and [VOLUME -](4) buttons for about 6
seconds to reset the soundbar to the factory settings.
• The soundbar restarts after asuccessful reset.
Note
• Resetting to the factory default settings can solve
some problems and malfunctions.
• However,all settings made previously,such as custom
equaliser presets, favourites, and network proles, are
permanently deleted.
To Next Page
Loading...
Need help?
General
