10
How to Program (After the Time has Been Set)
32
For the first time you program, press and hold
button for 3 seconds until “19:99” flashes on
display. While continuing to hold the
button. “12:00” will flash on display.
Set time according to “How to Set the Time for the First Time” on page 9.
1
5
4
The blue light around the
button will illuminate to indicate
the unit will automatically start
at your desired time. After the
program autostart time has been
set, the autostart sequence can
be toggled on/off by pressing
the
button for less than
1 second. To review the autostart
time, press the
button
and hold for 3 seconds. After the
initial program setting, time will
default to the last programmed
autostart time set.
Press and release
button
again to set autostart.
840239700 ENv20.indd 10 10/22/14 4:52 PM
To Next Page
Loading...
