Step 1
□
Do not operate the tower fan without the base. The tower fan base is composed of two pieces (BASE FRONT and BASE BACK).
The base needs to be connected together prior to attaching it to the tower fan. Align, and then insert, the plastic pegs of the BASE
BACK with the holes on the BASE FRONT until both pieces snap together.
Step 2
□
Now that the base is connected together, find the plastic nut that is installed on the bottom of the fan body.Take out the plastic nut
by rotating it counter-clockwise. Thread the tower fan's power cord through the hole in the middle of the base.
Step 3
□
Next, align the base mount guide peg with the guide hold located on the base. The base will only fit onto the tower fan one way.
Once the base is properly aligned on the bottom of the tower fan, add the plastic nut and rotate it clockwise to secure the base.
To Next Page
Loading...
