Electrical Shock Hazard
. Plug unit only into grounded electrical outlet,
• Do not use an extension cord or plug adaptor with
this unit.
3, Do not operate unit with front relnoved.
Failure to follow the above precautions could result in electrical
shock, fire or personal injury,
If the dehumidifier has a serial plate rating of 115 volts
and up to and including 7.5 amps tile unit may be on a fuse
or circuit breaker with other devices. However, the maximum
amps of all devices on that fuse or circuit breaker can not exceed
the amps of the filse or circuit breaker,
The Ioc,ltion of tile serial plate that applies to this model
can be found on tile back page of this manual.
Notice
Do not operate this dehumidifier without proper time delay
circuit protection. Refer to serial plate for proper power sup-
ply requirements.
RECOMMENDED CIRCUIT WIRE SIZES
(As installed per building code)
PROTECTORSIZE WIRE GAUGE
15 AMP #14 MINIMUM
20 AMP #12 MINIMUM
30 AMP #10 MINIMUM
@©©@
115V 230V 230V 230V
15A 15A 20,4 30,4
For Your Safety:
Do riot store or use gasoline or other flammable vapors an(]
li( uids in tile vicinity of this or any other appliance. Tile
fumes can create a tire lazar( or exp osion.
Power Supply: 775
125 V, 15 J
Minimum Wire Size: #14 M.
Circuit Protecton
or Circuil
1. ELECTRICAL REQUIREMENTS
Grounded
Single outlet
three-prong
ir_l
grounding
wall receptacle wall receptacle
Three-prong
grounding plug
important
Grounding Requirements
Your Dehumidifier will operate on any 115 volt,
3-pronged (grounded), 60 Hz circuit. A separate
line is not required, but it is advisable not to over-
load the circuit with heavy duty appliances such
as washing machines, etc. For your safety, this
dehumidifier is equipped with a 3-pronged,
grounding plug and must be plugged into a prop-
erly grounded outlet (Figs, 1 & 2), If your outlet is
not of the proper type, it is your responsibility to
have the outlet and wiring changed to the correct
type. DO NOT cut off the third (grounding) prong.
DO NOT USE AN ADAPTER.
To Next Page
Loading...